Newer
Older
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
; Offset in the spectrometer momentum.
hmomentum_factor = 0.000 ; leave 0 so it will have no effect
; use hpcentral_offset if one needs to offset central momentum
;
; The hdelta_offset,htheta_offset,hphi_offset effect the
; reconstructed target quantities. Used in h_targ_trans.f
; For transport x is in the dispersive direction with + down
; y is in the horizontal + towards small angles.
; z is along the central optics axis.
; In transport coordinates phi = hyptar = dy/dz and theta = hxptar = dx/dz
; but for unknown reasons the yp offset is named htheta_offset
; and the xp offset is named hphi_offset
; Do not to change these values, since these are the zero order
; CMOP matrix elements. If you do change then your hms sieve
; plots will be screwed up.
hdelta_offset = 0. ; (%) hdelta_tar = hdelta_tar + hdelta_offset
htheta_offset = 4.83e-5 ; (rad) hyp_tar = hyp_tar + htheta_offset
hphi_offset = -4.73e-3 ; (rad) hxp_tar = hxp_tar + hphi_offset
;
;saturation correction flag
genable_hms_satcorr = 2000 ;(0=disabled) - h_satcorr.f
; a correction to hsdelta event by event
; for a problem in setting Q3 current.
; There was an unknown zero offset in the Q3 current.
; The magnet setting code field00.f partially
; fixes this problem. T. Horn in 2003 determined
; the corrections to delta.
; Data taken with fields set by field99.f or earlier should set to 1999.
; Data taken with fields set by field00.f or later should set to 2000.
; central field correction
genable_hms_fieldcorr = 1 ; (1=disabled) - h_fieldcorr.f
; Need to enable for experiments before Jan 2002 .
; experiments using field02 and field03 should disable.
;
; The following offsets are applied to the central kinematic variables
; in h_apply_offsets.f . These might be modified by an experiment
; after doing calibration with elastic ep.
; The values below are from T. Horn 2003 analysis
hpcentral_offset = -0.25 ; sets hpcentral = hpcentral * ( 1. + hpcentral_offset / 100. )
; experiments earlier than April 2003
; should use about -0.3 which is the best
; estimate based on several previous experiments.
hthetacentral_offset = 0.0002 ; (rad)
;htheta_lab=htheta_lab + hthetacentral_offset/degree
; This offset is determined from elastic ep data.
; Must be added to ssxptar when used in calculating lab angles.
; Example is in h_physics.f
;
h_oopcentral_offset = 0.0011 ; (rad)