Modify PARAM file hmsflags.param

Changed to use name hsatcorr for the HMS correction.
Set theta and oop central offsets to 0.
Historically they were small.
These will be determined by the heepcheck

Left hpcentral_offset = -0.025 the historical value.
This will be checked by heepcheck.

PARAM/HMS/GEN/hmsflags.param

@@ -19,7 +19,7 @@
 ;
 
 ;saturation correction flag
-  genable_hms_satcorr = 2000 ;(0=disabled) - h_satcorr.f
+  hsatcorr = 2000 ; 
                           ; a correction to hsdelta event by event
                           ; for a problem in setting Q3 current.
                           ; There was an unknown zero offset in the Q3 current.
@@ -28,25 +28,12 @@
                           ; the corrections to delta.
                           ; Data taken with fields set by field99.f or earlier should set to 1999.
                           ; Data taken with fields set by field00.f or later should set to 2000.
+; These offsets are determined from elastic ep data.
 ; central field  correction
-  genable_hms_fieldcorr = 1 ; (1=disabled) - h_fieldcorr.f 
-                            ; Need to enable for experiments before Jan 2002 .
-			    ; experiments using field02 and field03 should disable. 
-;
-; The following offsets are applied to the central kinematic variables
-;  in h_apply_offsets.f  . These might be modified by an experiment
-;  after doing calibration with elastic ep.
-; The values below are from T. Horn 2003 analysis
-  hpcentral_offset = -0.25   ; sets hpcentral = hpcentral * ( 1. + hpcentral_offset / 100. )
-		    ; experiments earlier than April 2003 
-                    ; should use  about -0.3 which is the best
-                    ; estimate based on several previous experiments.
-  hthetacentral_offset = 0.0002 ; (rad) 
-                         ;htheta_lab=htheta_lab + hthetacentral_offset/degree 
-; This offset is determined from elastic ep data.
-; Must be added to ssxptar when used in calculating lab angles.
-; Example is in h_physics.f
-;
-  h_oopcentral_offset = 0.0011  ; (rad)
+  hpcentral_offset = -0.025   
+  hthetacentral_offset = 0.000 ; (rad) 
+  h_oopcentral_offset = 0.00  ; (rad)
+; sets hpcentral = hpcentral * ( 1. + hpcentral_offset / 100. )
+;      htheta_lab=htheta_lab + hthetacentral_offset/degree