diff --git a/CALIBRATION/shms_dc_calib/README.md b/CALIBRATION/shms_dc_calib/README.md
index 725ac087546fdf2a78efb9465c4e5e1f2f4e2216..efb52584c9cb0cd3849f4d4f2934adfcfbf6b3a6 100644
--- a/CALIBRATION/shms_dc_calib/README.md
+++ b/CALIBRATION/shms_dc_calib/README.md
@@ -30,7 +30,7 @@ Running code
 
 * Rename the new parameter files as follows:
   * copy: pdc_tzero_per_wire_run%d_NEW.param to pdc_tzero_per_wire.param
-  * copy: pdriftmap_new.param to pdriftmap.param
+  * copy: pdriftmap_run%d_NEW.param to pdriftmap.param
 
 * Before replaying the data again, set the parameter 'p_using_tzero_per_wire = 1' to 
   allow the source code (hcana) to read the parameter values during the replay.
@@ -66,7 +66,7 @@ Brief decription of code
 		   Also contains two "tzero vs. wirenumber" plots: one for all wires, and the other is after setting tzero=0 for
                    wires that did not have enough statistics for a good quality fit, a weighted average was calculated for the latter.  
 		   
-		-- outputs data_file: 'shms_dc_planetzero_run%d.dat'         -> contains list of "tzero" values for all wires  	
+		-- outputs data_file: 'shms_dc_planetzero_run%d.dat'         -> contains list of "tzero" values for all wires  (plane e.g. 2u1, 1x2, ...) 	
 		   	   	      'shms_dc_planetzero_run%d_updated.dat' -> contains list of "tzero" values for all wires that
 				      					     	had a good fit. The remaining tzeros are set to 0.
 				      'tzero_weighted_avg_run%d.dat          -> contains weighted tzero values per plane 
@@ -78,11 +78,11 @@ Brief decription of code
 		-- outputs param_file: /hallc_replay/PARAM/SHMS/DC/pdc_tzero_per_wire_run%d_NEW.param, where %d=run_number
                 -- contains tzero values for all wires in all planes, but the file is formatted so that the values may be read by the source code (hcana)
 	  
-	** get_pdc_time_histo_tzero_corrected.C  	  	
-	   	-- outputs root_file: 'shms_tzero_corr_histos.root'
+	** get_pdc_time_histo_tzero_corrected_v2.C  	  	
+	   	-- outputs root_file: 'shms_tzero_corr_histo.root'
 		-- contains list of "t0-corrected" wire drift times, and their respective plane drift times.
 
 	** get_LookUp_Values.C
-	        -- outputs param_file: /hallc_replay/PARAM/SHMS/DC/pdriftmap_new.param
+	        -- outputs param_file: /hallc_replay/PARAM/SHMS/DC/pdriftmap_run%d_NEW.param
  		-- contains scaling factors calculated from the corrected plane drift times on a bin-by-in basis. These values get read by the source code
 		   which will be used to scale the drift distance histograms.